Common Consideration

• The crack or opening must be properly prepared. An indentation of about 2 cm deep and thick should be created for proper application.
• Cut the indentation so that the edges are nearly perpendicular to the surface (squareshaped) but do not make it “V”-shaped.
• Clean the surface of any dirt, loose particles or any other residue.
• Add small amount of potable water to Zahabiya AQUAPATCH and mix until it becomes putty like consistency. It can then be applied to the area affected either by hand or with a metal trowel.
• Only mix as much AQUAPATCH that you can use in one or two minutes.
• Apply AQUAPATCH keeping a good hold of it, esp. against running water.
• AQUAPATCH should be pressed into the indentation to obtain best results.
• Once it has been applied, keep it damp for at least sixty minutes.
• AQUAPATCH can be used above and below groundwater levels in: basements, tunnels, sewers, tanks, around piping, cable conduits etc., or anywhere water is not desired.